Chapter 23
| LLDP Commands
lldp dot3-tlv link-agg
lldp dot3-tlv mac-phy
Command Usage
This option advertises the name of all VLANs to which this interface has been
assigned. See the
switchport allowed vlan
group (Configuring Interfaces)" on page
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv vlan-name
Console(config-if)#
This command configures an LLDP-enabled port to advertise link aggregation
capabilities. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv link-agg
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises link aggregation capabilities, aggregation status of the link,
and the 802.3 aggregated port identifier if this interface is currently a link
aggregation member.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv link-agg
Console(config-if)#
This command configures an LLDP-enabled port to advertise its MAC and physical
layer capabilities. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv mac-phy
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
command and
491.
– 610 –
"protocol-vlan protocol-