Rspan Source - Edge-Core ECS4210-12P Reference Manual

Chapter 13
| Port Mirroring Commands
RSPAN Mirroring Commands

rspan source

RSPAN uplink ports cannot be configured to use IEEE 802.1X Port
Authentication, but RSPAN source ports and destination ports can be
configured to use it
◆
Port Security – If port security is enabled on any port, that port cannot be set as
an RSPAN uplink port, even though it can still be configured as an RSPAN source
or destination port. Also, when a port is configured as an RSPAN uplink port,
port security cannot be enabled on that port.
Use this command to specify the source port and traffic type to be mirrored
remotely. Use the no form to disable RSPAN on the specified port, or with a traffic
type keyword to disable mirroring for the specified type.
Syntax
[no] rspan session session-id source interface interface-list [rx | tx | both]
session-id – A number identifying this RSPAN session. (Range: 1)
Only one mirror session is allowed, including both local and remote
mirroring. If local mirroring is enabled, then no session can be configured
for RSPAN.
interface
ethernet unit/port-list
unit - Unit identifier. (Range: 1)
port-list - One or more source ports. Use a hyphen to indicate a
consecutive list of ports or a comma between non-consecutive
ports. (Range: 1-12/28)
rx - Mirror received packets.
tx - Mirror transmitted packets.
both - Mirror both received and transmitted packets.
Default Setting
Both TX and RX traffic is mirrored
Command Mode
Global Configuration
Command Usage
◆
One or more source ports can be assigned to the same RSPAN session, either on
the same switch or on different switches.
◆
Only ports can be configured as an RSPAN source – static and dynamic trunks
are not allowed.
◆
The source port and destination port cannot be configured on the same switch.
– 386 –