AT&T Unix Owner's Manual page 330

Maintaining the UNIX PC
4-94
Note
If you should a problem with the floppy
disk, you must start the backup
procedure from the beginning. Remove
and discard the damaged floppy disk.
Begin the backup again.
8 Press <Enter> after inserting each floppy
disk.
When the backup is complete, you are prompted
to remove the last floppy disk. Then the
following prompt appears to let you verify
the data on the floppy disks: Do you wish to
cheCk the data on the floppy disk(s)?
9 If you want to verify the data on the floppy
backup disks, continue on to step 10.
If you do not want to verify the floppy
backup disks, press <Cancl>. You see a
confirmation that the backup is complete.
10 To verify the data on the backup floppy
disks, press <Enter>.
You are prompted to insert the floppy backup
disks one by one, starting with the first in
the set.
When the last floppy backup disk has been
checked, a confirmation message tells you
that the backup is complete.
11 Remove the last floppy backup disk and press
<Enter>.