Product Upgrades; Determine The Installed Revision Of Firmware; Perform A Firmware Upgrade; Embedded Web Server - HP LASERJET ENTERPRISE M725dn Troubleshooting Manual

Product upgrades

To download the most recent firmware upgrade for the product, go to
ljMFPM725_firmware.

Determine the installed revision of firmware

Print a configuration page to determine the installed revision of firmware.
On the configuration page, look in the section marked Device Information for the firmware datecode
and firmware revision.
Firmware datecode and firmware revision examples
20100831 (firmware datecode)
●
103067_104746 (firmware revision)
●

Perform a firmware upgrade

The firmware bundle is a xxxxxxx.bdl file. This file requires an interactive upgrade method. You
cannot upgrade the product using the traditional FTP, LPR or Port 9100 methods of upgrading. Use one
of the following methods to upgrade the firmware for this product.

Embedded Web Server

1.
Open a Web browser window on the computer.
2. Enter the product IP address in the address bar, and then press Enter.
3. Select the Firmware upgrade link from within the Troubleshooting tab.
NOTE:
from the Security tab.
4.
Browse to the location that the firmware upgrade file was downloaded to, and then select the
firmware file. Select the Install button to perform the upgrade.
NOTE:
confirmation page.
5. Select Restart Now from the EWS confirmation page, or turn the product off, and then on again
using the power switch.
468 Chapter 2 Solve problems
If you get a warning screen, follow the instructions for setting an administrator password
Do not close the browser window until the Embedded Web Server (EWS) displays the
www.hp.com/go/
ENWW