HP LASERJET ENTERPRISE M725dn Troubleshooting Manual page 319

Table 2-28 Jetdirect Menu
First level Second level
Link Speed
ENWW
(continued)
Third level Fourth level Values
Auto*
10T Half
10T Full
10T Auto
100TX Half
Description
The link speed and
communication mode
of the print server
must match the
network. The
available settings
depend on the
product and installed
print server. Select
one of the following
link configuration
settings:
CAUTION:
change the link
setting, network
communications with
the print server and
network product
might be lost.
The print server uses
auto-negotiation to
configure itself with
the highest link
speed and
communication mode
allowed. If auto-
negotiation fails,
either the 100TX Half
feature or the
Half feature is set
depending on the
detected link speed
of the hub/switch
port. (A 1000T half-
duplex selection is
not supported.)
10 Mbps, half-
duplex operation.
10 Mbps, full-duplex
operation.
100 Mbps, half-
duplex operation.
100 Mbps, full-
duplex operation.
Tools for troubleshooting
If you
10T
287