8.
After the alignment operation is complete, the stapler/stacker controller turns on the stamp
solenoid and the stamp clamps against the paper, so that the paper on the jogger guide is not
pushed out by the following paper. At the same time, the stapler/stacker controller moves the
jogger guide and the leading end alignment roller to the waiting position.
Figure 1-76
Alignment-alienation solenoid
9.
The stapler/stacker repeats the preceding steps until the last sheet of the job is fed.
10.
When the last sheet of the job is fed, the stapler/stacker controller performs the stapling operation,
if the product is in the staple mode. Then, the stapler/stacker controller engages and rotates the
output upper roller and the output lower roller to feed the paper stack. If the product is in the stack
align mode, the stapler/stacker controller engages and rotates the output upper roller and the
output lower roller to feed the paper stack without stapling.
104
Chapter 1 Theory of operation
Alignment complete
Leading end alignment roller
M2102
Alignment-alienation motor
SL2102
Stamp solenoid
SL2101
Stamp
Jogger guide
Jogger motor
M2100
ENWW