Format Disk
The
2 Format Disk
CAUTION:
Characteristics of a Format Disk
Customer-defined settings, third-party solutions, firmware files, and the operating system are
●
deleted.
NOTE:
Rebooting the product restores the firmware files from the Repository location, but does not restore
●
any customer-defined settings.
After executing the
●
After executing the
●
CAUTION:
the solution in the product service manual recommends this solution. After executing the
function, the product is unusable.
HP recommends backing-up product configuration data before executing a
to retain customer-defined settings. See the
Reasons for performing a Format Disk
The product continually boots up in an error state.
●
NOTE:
The product will not respond to commands from the control panel.
●
Executing the
●
To reset the product by deleting all solutions and customer-defined settings.
●
Execute a 2 Format Disk
1.
Turn the product on.
2.
Touch the HP logo that displays in the center of the touchscreen until the Preboot menu opens.
3.
Use the down arrow
4.
Use the down arrow
5.
Touch the
NOTE:
firmware.
454
Chapter 2 Solve problems
option erases the entire disk drive.
After executing a
2 Format Disk
Rebooting the product does not restore the firmware files.
2 Format Disk
2 Format Disk
HP recommends that you do not use the
Try clearing the error prior to executing a
2 Format Disk
function is helpful for troubleshooting hard disk problems.
button to highlight
button to highlight
OK
button again.
When the
2 Format Disk
option, the product is not bootable.
function, the message 99.09.67 displays on the control panel.
function, the product firmware must be reloaded.
2 Format Disk
Backup/Restore
item in the
2 Format
3
Administrator, and then touch the
2 Format
Disk, and then touch the
operation is complete, you will need to reload the product
option unless an error occurs and
2 Format Disk
2 Format
Disk, if you need
Device Maintenance
Disk.
OK
button.
OK
button.
menu.
ENWW