Table of Contents
Advertisement
13.E1.FF Jam in left door
Description
Power on residual paper jam. This jam occurs when paper exists at any of the paper path jam sensors
when the product power is turned on or after jam re-evaluation.
Recommended action
1.
Open the left door, remove any jammed paper, and then close the left door.
2.
Inspect the connectors on the paper delivery assembly.
3.
Use the Tray/bin manual sensor tests to toggle the output bin full sensor (SR4). If the sensor or
lever are not properly functioning, replace the paper delivery assembly.
13.E6.AX Jam in left door
Description
Stopped at output jam. This jam occurs when the paper fails to clear the output sensor (SR3) within a
specific time.
X indicates the fuser mode
2 = Normal
◦
3 = Light media 1
◦
3 = Light media 2
◦
4 = Heavy media 1
◦
5 = Heavy media 2
◦
B = Transparency
◦
D = Envelope 1
◦
D = Envelope 2
◦
Recommended action
1.
Open the left door, remove any jammed paper, and then close the left door.
2.
Check the paper path and rollers at the fuser and the paper delivery assembly for damage or
wear. Replace the fuser or paper delivery assembly if necessary.
3.
Use the Tray/bin manual sensor tests to toggle the output bin full sensor (SR4). If the sensor or
lever are not properly functioning, replace the paper delivery assembly.
4.
Use the Manual sensor tests to toggle the output sensor (SR3). If the sensor or lever are not
properly functioning, replace the paper delivery assembly.
ENWW
Tools for troubleshooting
321
Advertisement
Table of Contents
Troubleshooting
