Network Settings menu
To display: At the product control panel, select the
Settings
menu.
In the following table, asterisks (*) indicate the factory default setting.
Table 2-27 Network Settings
First level
I/O Timeout
Jetdirect Menu
Table 2-28 Jetdirect Menu
First level
Second level
Information
Print Sec Report
TCP/IP
Enable
Host Name
ENWW
menu
Values
Range: 5 – 300 sec
Default = 15
See the table that follows for details. These
menus have the same structure. If an
additional HP Jetdirect network card is
installed in the EIO slot, then both menus are
available.
Third level
Administration
menu, and then select the
Description
Use to set the I/O timeout period in seconds.
I/O timeout refers to the elapsed time before
a print job fails. If the stream of data that the
product receives for a print job gets
interrupted, this setting indicates how long
the product will wait before it reports that the
job has failed.
Fourth level
Values
Yes
No*
On*
Off
Use the arrow
buttons to edit the
host name.
NPIXXXXXX*
Network
Description
Yes: Prints a page
that contains the
current security
settings on the
HP Jetdirect print
server.
No: A security
settings page is not
printed.
On: Enable the TCP/
IP protocol.
Off: Disable the
TCP/IP protocol.
An alphanumeric
string, up to 32
characters, used to
identify the product.
This name is listed on
the HP Jetdirect
configuration page.
The default host
name is NPIxxxxxx,
where xxxxxx is the
last six digits of the
LAN hardware
(MAC) address.
Tools for troubleshooting
275