Print/stop test
Use this diagnostic test to isolate the cause of problems such as image-formation defects and jams
within the engine. During this test you can stop the paper anywhere along the product paper path. You
can program the test to stop printing internal pages or an external print job when the paper reaches a
certain position. You can also program the test to stop from 0 to 60,000 ms. If the timer is set to a
value that is greater than the job-print time, you can recover the product in one of two ways.
1.
From the Home screen, scroll to and touch the
2.
Touch the
3.
Touch the
4.
Scroll to and touch the
5.
Enter a range, and then touch the
After the print job is completed, press the
●
the timer times out.
After the timer times out, touch the
●
return it to a normal state.
NOTE:
Do not try to perform a print/stop test while the product is calibrating because you might be
required to restart the product. If a jam message displays on the control panel during testing, activate
the door switch.
ENWW
Troubleshooting
button.
Diagnostic Tests
button.
Print/Stop Test
Administration
button.
OK
button.
OK
button to return to the
Stop
button. Activate the door switch to restart the engine and
button.
Troubleshooting
menu before
Tools for troubleshooting
183