Send-Fax Messages; Table 2-36 Send-Fax Messages - HP LASERJET ENTERPRISE M725dn Troubleshooting Manual

Send-fax messages

Table 2-36 Send-fax messages
Message
Cancelled
Success
Fail Busy
No Answer
No Dial
Failed
Failed
Failed
Failed or Communication
Error
Space Fail
Memory Error
Power Failure
ENWW
Error No.
0
n/a
0
0 or 17
0
Any
0
17 or 36
Any besides 17 or 36
0
0
0
Description
Someone cancelled the fax at the
product control panel.
The fax was sent successfully.
The receiving fax machine is
busy.
The receiving fax machine is not
answering the call, or a person
answered the call.
No dial tone is detected when
sending the fax.
The fax might be corrupted or
not sent.
Incompatible page width, or
page had too many bad lines.
Lost telephone connection
between sender and receiver.
The issue might be due to voice
calls interrupting the fax, or a
person answering the call.
General communications issue
where the fax transmission was
interrupted or did not proceed as
expected.
Unable to read or write the fax
image file to disk; could be
corrupt product disk or no space
available on the product's disk.
Out of memory on product.
A power failure occurred on the
sending fax product during the
fax transmission.
Action
None.
None.
The fax will be retired
automatically (if configured),
otherwise try resending fax later.
The receiving fax machine might
be disconnected or turned off;
contact the receiver to check the
machine. Try resending.
Verify the phone line is active;
set the sending fax to "not" to
detect a dial tone.
Try resending fax.
Try resending fax; if the error
persists, contact service.
Try resending the fax.
Try resending fax; if the error
persists, contact support.
Try resending fax; if the error
persists, contact support.
If the error persists, delete items
from the product memory, such
as stored jobs or saved faxes.
Try resending the fax.
Solve fax problems
465