Partial Clean; Execute A 3 Partial Clean - HP LASERJET ENTERPRISE M725dn Troubleshooting Manual

Partial Clean

The 3 Partial Clean
repository where a backup copy of the firmware file is stored. This allows the disk drive to be
reformatted without having to download a firmware upgrade file to return the product to a bootable
state.
Characteristics of a Partial Clean
Customer-defined settings, third-party solutions, firmware files, and the operating system are
●
deleted.
Rebooting the product restores the firmware files from the Repository location, but does not restore
●
any customer-defined settings.
For previous HP products, a Hard Disk Initialization is similar to executing the
●
function for this product.
CAUTION:
Clean, if you need to retain customer-defined settings. See the
Maintenance
Reasons for performing Partial Clean
The product continually boots up in an error state.
●
NOTE:
The product will not respond to commands from the control panel.
●
Executing the
●
To reset the product by deleting all solutions and customer-defined settings.
●
The product default settings are not properly working.
●

Execute a 3 Partial Clean

1.
Turn the product on.
2. Touch the HP logo that displays in the center of the touchscreen until the Preboot menu opens.
3. Touch the down arrow
4. Use the down arrow
5. Touch the
6. Touch the
NOTE:
ENWW
option erases all partitions and data on the disk drive, except for the firmware
HP recommends backing-up product configuration data before executing a
menu.
Try clearing the error prior to executing a
3 Partial Clean function is helpful for troubleshooting hard disk problems.
button to highlight
button to highlight
OK button again.
Home button to highlight
The product initializes.
Backup/Restore
3 Partial
3 Administrator, and then touch the
3 Partial Clean, and then touch the
1 Continue, and then touch the
3 Partial Clean
item in the
Clean.
OK
OK button.
OK button.
Service mode functions
3 Partial
Device
button.
453