Table of Contents
Advertisement
DC controller, J6 and J47
●
High-voltage power supply, J902
●
5.
Use the Components tests to activate the fuser drive motor (listen for the motor to rotate). If the
motor is not properly functioning, replace the fuser.
20.00.00 Insufficient memory: <Device> To continue, touch "OK"
Description
The product has experienced a memory error. You might have tried to transfer too many fonts or
macros.
Recommended action
Press the
OK
or add product memory.
21.00.00 Page too complex To continue, touch "OK"
Description
The page decompression process was too slow for the product.
Recommended action
Press the
OK
30.01.01
Description
The flatbed cover sensor was interrupted.
Recommended action
No action necessary. This error message should automatically clear.
If the error persists, open the Scanner Tests to test the Flatbed cover sensor.
30.01.06
Description
A scan control board fan error has occurred.
Recommended action
1.
Turn the product off, and then on.
2.
Replace the scan control board.
3.
If the error persists, replace the scanner assembly.
ENWW
button to print the transferred data. Some data might be lost. Reduce the page complexity
button to continue. There may be some data loss.
Tools for troubleshooting
325
Advertisement
Table of Contents
Troubleshooting
