Other Copier Problems And Errors; Ink Is Not Drying; Cover Or Door Will Not Close; Copier Is In Factory Mode - HP 610 Reference Manual

other copier problems and errors

ink is not
drying
cover or door
will not close
copier is in
factory mode
copier is
initializing
improper
power off
troubleshoot your digital copier
The following issues relate to other miscellaneous problems and errors that
might occur.
If you are copying transparencies or other media, they require a longer
than normal drying time. Leave the media in the output tray until dry.
If necessary, carefully remove the copied media. Hold them from the
underside or the edges, and then place them on a flat surface to dry.
For more information, see recommended paper types on page 11.
Make sure the HP Digital Copier is on an even surface. Make sure there is
nothing blocking the door from closing.
The settings on your HP Digital Copier are not correct. Call HP for
instructions.
If you see this message on the front panel, wait until the HP Digital Copier
finishes its start-up routine.
If you see this message, your HP Digital Copier was not turned off properly
the last time it was used.
Press the On button on the front panel of the HP Digital Copier whenever
you need to shut down the unit. This allows the print carriage to be properly
parked in the print station on the right. If HP Digital Copier is turned off
hp digital copier series
69