Table of Contents
Advertisement
5. Slide the selector switch to the 400V location.
6. Re-attach the front panel.
Adjust the projector tilt and level
Warning! Failure to comply with the following could result in death or serious injury.
• The projector's rear safety strap must be in place before adjusting the projector feet.
• Do not over-extend the feet. Make sure several threads are engaged into the projector's baseplate
to secure the projector from falling.
Adjust the projector tilt to fill the maximum amount of screen while minimizing keystone. Lens
offset can be used to center the image in the center of the screen..
Notice. Failure to comply with the following may result in property damage.
The front-to-back tilt of the projector must not exceed 15 degrees.
1. Secure a safety lifting strap rated to handle the projector weight at the rear of the projector.
2. Hoist up the projector.
3. To adjust the vertical or horizontal position of the projector, extend or retract the adjustable
feet on the bottom of the projector (A).
Mirage 4K35 User Manual
020-101377-03 Rev. 1 (07-2015)
Installation and Setup
31
Advertisement
Table of Contents
