Adjust Tilt And Level The Cinema Projector - Christie CP2220 Setup Manual

3. Attach the supplied safety strap to the back of the cinema projector and fasten it to its mounting surface.
Use of the strap is mandatory to prevent the cinema projector from tipping when a lens or auxiliary lens
mount is installed. NOTE: If you are using the optional rack stand, it is strongly recommended you use the
hold down clamp (116-100101-01) in addition to the rear safety strap to firmly secure the cinema
projector's rear feet.
2.6

Adjust Tilt and Level the Cinema Projector

WARNING! The cinema projector's rear safety strap must be in place before you adjust the
cinema projector's feet.
The CP2220 lens should be centered and parallel with the screen. This orientation ensures optimum lens
performance with minimal offset. If this position is not possible (such as when the cinema projector is
significantly higher than the center of the screen), it is better to rely on offset rather than extra tilt.
Use a protractor to measure the degree of screen tilt and then extend or retract the cinema projector feet to
match this angle.
NOTE: The front-to-back tilt of the cinema projector must not exceed 15°.
This limit ensures safe lamp operation and the proper positioning of the
liquid cooling reservoir.
To adjust the vertical or horizontal position of the cinema projector, extend
or retract the adjustable feet on the bottom of the cinema projector by
rotating them. Once the required adjustment is made, tighten the lock nut.
2-6
Figure 2-2 Position the cinema projector
Figure 2-3 Adjust Feet
CP2220 Setup Guide
020-100476-05 Rev. 1 (05-2014)