Parksense Front/Rear Park Assist; System - If Equipped - Jeep GRAND CHEROKEE 4xe 2023 Owner's Manual

The Active Driving Assist system DOES NOT:
Warn or prevent collisions with other vehicles

Steer your vehicle around stopped vehicles,

slower vehicles, construction zones or equip-
ment, pedestrians, or animals
Respond to traffic lights or stop signs

Merge onto highways or exit off ramps

Change lanes or turn

React to cross traffic

NOTE:
Adaptive Cruise Control (ACC) is a core component
of ADA. For ACC system limitations Ú page 152.
The Active Driving Assist system may have limited
or reduced functionality when one of the following
conditions occur:
The vehicle's radar sensors and/or forward

facing camera is damaged, covered,
misaligned, or obstructed (e.g. by mud, ice,
snow, etc.)
If the suspension alignment is not correct, if the

vehicle is modified (e.g. lifting or lowering the
suspension, installing different sized wheels or
tires) or if there has been damage due to road
hazards
Driving near highway toll booths

NOTE:
If damage to the windshield occurs, have the wind-
shield replaced by an authorized dealer as soon as
possible.

PARKSENSE FRONT/REAR PARK ASSIST

SYSTEM — IF EQUIPPED
The ParkSense Park Assist system provides visual
and audible indications of the distance between
the rear, and if equipped, the front fascia/bumper
and a detected obstacle when backing up or
moving forward (e.g. during a parking maneuver).
The vehicle brakes may be automatically applied
and released when performing a reverse parking
maneuver if the system detects a possible collision
with an obstacle.
STARTING AND OPERATING
NOTE:
The driver can disable the automatic braking

function by turning ParkSense off via the Park-
Sense switch. The driver can also override auto-
matic braking by changing the gear or by
pressing the gas pedal over 90% of its capacity
during the braking event.
Automatic brakes are not available if the vehicle

is in 4WD Low.
Automatic brakes will not be available if there is

a faulted condition detected with the ParkSense
Park Assist system or the Braking System
Module.
The automatic braking function may only be

applied if the vehicle deceleration is not enough
to avoid colliding with a detected obstacle.
The automatic braking function may not be

applied fast enough for obstacles that move
toward the rear of the vehicle from the left and/
or right sides.
The automatic braking function can be

enabled/disabled from the Customer Program-
mable Features section of the Uconnect system.
ParkSense will retain its last known configura-

tion state for the automatic braking function
through ignition cycles.
167
4