Axle Lock (Tru-Lok) Rear Only - If Equipped; Electronic Sway Bar Disconnect - If Equipped - Jeep WRANGLER 2023 Owner's Manual

Hide thumbs Also See for WRANGLER 2023:
Table of Contents

Advertisement

140
STARTING AND OPERATING
NOTE:
The indicator lights will flash until the axles are fully
locked or unlocked.
To unlock the axles, push the AXLE LOCK OFF button.
Axle Lock will disengage if the vehicle is taken out of
4L, or the ignition switch is turned to the OFF position.
The Axle Lock disengages at speeds above 30 mph
(48 km/h), and will automatically re-lock once vehicle
speed is less than 10 mph (16 km/h).
The axle lock disengages at speeds above 48 km/h
(30 mph), and will automatically re-lock once vehicle
speed is less than 16 km/h (10 mph).
The axle lock disengages at speeds above 48 km/h,
and will automatically re-lock once vehicle speed is less
than 16 km/h.
AXLE LOCK (TRU-LOK) REAR ONLY
— IF EQUIPPED
The rear axle may be locked in 4H if the proper condi-
tions are met.
WARNING!
This mode is intended for off-highway or off-road use
only and should not be used on any public roadways.
The AXLE LOCK switch is located on the instrument
panel (to the right of the steering column).
Axle Lock Switch Panel
This feature will only activate when the following condi-
tions are met:
Ignition in RUN position, vehicle in 4H.
The vehicle must be in Off Road+ active
page 141.
Vehicle must be in ESC "Full Off" mode
page 236.
Vehicle must not be actively in a high wheel slip or
tight cornering condition.
To activate the system, push the AXLE LOCK switch
down to lock the rear axle only ("REAR ONLY" will
illuminate).
To unlock the rear axle, push the AXLE LOCK OFF
button.
Axle Lock will disengage if the vehicle is taken out of
4H, Off Road+ is turned off by the driver, ESC "Full Off"
is exited, or the ignition switch is turned to the OFF
position.
NOTE:
The indicator lights will flash until the rear axle is fully
locked or unlocked.
The rear Axle Lock system may temporarily disengage
the rear locker under some conditions.
If this occurs, the rear axle will automatically re-lock as
soon as the system allows.
ELECTRONIC SWAY BAR
DISCONNECT — IF EQUIPPED
Your vehicle may be equipped with an electronic discon-
necting stabilizer/sway bar. This system allows greater
front suspension travel in off-road situations.
This system is controlled by the SWAY BAR switch
located on the instrument panel (to the right of the
steering column).
SWAY BAR Switch
Push the SWAY BAR switch to activate the system. Push
the switch again to deactivate the system. The Sway
Bar Indicator Light (located in the instrument cluster)
will illuminate when the bar is disconnected. The Sway
Bar Indicator Light will flash during activation transition,
or when activation conditions are not met. The
stabilizer/sway bar should remain in on-road mode dur-
ing normal driving conditions.

Advertisement

Table of Contents
loading

Table of Contents