Axle Lock (Tru-Lok) Rear Only - If Equipped; Electronic Sway Bar Disconnect - If Equipped - Jeep Wrangler 2024 Owner's Handbook Manual

Hide thumbs Also See for Wrangler 2024:
Table of Contents

Advertisement

AXLE LOCK (TRU-LOK) REAR
ONLY — IF EQUIPPED
The rear axle may be locked in 4H if the proper
conditions are met.
WARNING!
This mode is intended for off-highway or off-
road use only and should not be used on any
public roadways.
The AXLE LOCK switch is located on the instru-
ment panel (to the right of the steering column).
Axle Lock Switch Panel
This feature will only activate when the following
conditions are met:
Ignition in RUN position, vehicle in 4H.
The vehicle must be in Off Road+ active.
Vehicle must be in ESC "Full Off" mode.
Vehicle must not be actively in a high wheel
slip or tight cornering condition.
To activate the system, push the AXLE LOCK
switch down to lock the rear axle only. To unlock
the rear axle, push the AXLE LOCK OFF button.
Axle Lock will disengage if the vehicle is taken
out of 4H, Off Road+ is turned off by the driver,
ESC "Full Off" is exited, or the ignition switch is
turned to the OFF position. The rear Axle Lock
system may temporarily disengage the rear
locker under some conditions.
Use this QR code to access your
digital experience.
ELECTRONIC SWAY BAR
DISCONNECT — IF EQUIPPED
Your vehicle may be equipped with an electronic
disconnecting stabilizer/sway bar.
SWAY BAR Switch
Push the SWAY BAR switch to activate the sys-
tem. Push the switch again to deactivate the sys-
tem. The Sway Bar Indicator Light (located in the
instrument cluster) will illuminate when the bar is
disconnected. The Sway Bar Indicator Light will
Scan me
flash during activation transition, or when activa-
tion conditions are not met. The stabilizer/sway
bar should remain in on-road mode during nor-
mal driving conditions.
INTERIOR
37

Advertisement

Table of Contents
loading

Table of Contents