Interrupting The Plotting Operation; Cut Off The Media By Hand - MIMAKI JV3-75 SP II Operation Manual

Interrupting the plotting operation

To interrupt the plotting operation, stop the carriage and erase (the receive data) from the device.
STEP
1. Press the [REMOTE] key to stop the plotting
operation.
2. If data is being transmitted from the computer
to the device, stop the data transmission.
3. Press the [DATA CLEAR] key.
The data that has been received is erased.
4. Press the [ENTER] key.
The device enters the LOCAL mode.

Cut off the media by hand

Cutting off the media at the end of the plotting operation is explained below.
• Do not turn off the main power switch on the rear face. If the main power
switch is turned off, the nozzle will be clogged.
• When Auto Cut has not been specified (
using the following procedure.
STEP
1. Put the device back into the LOCAL mode.
Press the [REMOTE] key and put the device back into the
LOCAL mode.
2. Press the JOG key until the LCD gives the
indication [ORIGIN SET UP].
Any of the JOG keys can be used.
3. Press the [FUNCTION] key.
4. Press the [ENTER] key.
Cut off the media that has been plotted on.
5. The device enters the LOCAL mode.
The device returns to its initial condition.
page 4.8), cut off the media
- 2.27 -
< LOCAL >
width : 1272 mm
DATA CLEAR
< ENT >
< LOCAL >
width : 1272 mm
< LOCAL >
width: 1272 mm
ORIGIN SET UP
0. 0 - - - - - -
MEDIA CUT
< ENT >
MEDIA CUTTING
PLEASE WAIT
< LOCAL >
width : 1272 mm