In Case Of Faultiness With Heater - MIMAKI JV3-75 SP II Operation Manual

3. Press the [ENTER] key.
The cursor is shown up on the LCD display, then can change
the Temp. of Pre-Heater.
4. Select the temperature by pressing the JOG
keys [ ] and [ ].
5. Press the Jog key [ ] to select the PRINT
HEATER.
The cursor moves on the indication of Print Heater, and can
change the Temp.
6. Change the temperature by pressing the JOG
keys [ ] and [ ]
7. Press the [ENTER] key.
8. Press the [HEATER] key.
Return to LOCAL or REMOTE mode.
When the Heater temp. is still increasing up to the set temp,
the LCD will be the right side of indication.
When the Heater temp. goes up to the set temp., the alarm
sounds, the CONSTANT indication of Pre-heater and Print
Heater turns on a light, then to be REMOTE mode.
• To start Printing before reaching the set temp.,
press [ENTER] key and return to REMOTE
mode.

In case of faultiness with Heater

In case the Power turns off, or the Heater is in problem, the LCD indicates below.
When pressing the [HEATER] key while indicating below, it shows Error message.
LOCAL mode
<LOCAL> ! HEATER
width: xxxxx mm
REMOTE mode
∗REMOTE∗ ! HEATER
TYPE. 1 0.0 0 m
- 2.20 -
Pre 40° 40° C
Print 35° 35° C
Pre 40° 45° C
Print 35° 35° C
Pre 40° 45° C
Print 35° 35° C
Pre 40° 45° C
Print 35° 40° C
Pre 40° C (
Print 35° C (
∗ REMOTE ∗
TYPE. 1 0. 0 0 m
TEMP. CONTROL
PLEASE WAIT
These two messages
alternately appear.
Pre 40° C (
Print 35° C (
45)
40)
45)
40)