Using The Small Amount Of Remaining Ink In The 440Cc Ink Cartridge - MIMAKI JV3-75 SP II Operation Manual

Using the small amount of remaining ink in the 440cc ink cartridge

For the 440cc ink cartrige, when [NEAR END] or [INK END] is displyed some ink may remain in
the ink cartridge. At this time it is possible to use remaining ink by selecting the amount.
• This function only supports 440cc ink cartridge which detecting [NEAR END]
or [INK END]. 220cc ink cartridge or [NEAR END] undetecting ink cartridge
are not supported.
• Even though this function is performed, [NEAR END] is not cleared there-
fore can not perform ink cleaning.
• Be careful that if additional amount of remaining ink exceed the actual
remaining amount, prinitng continues even ink ended. Furthermore air enter
the ink tube which cause abonormal printting.
A guide of ink amount to add
Ink cartridge weight
434g or below
435g - 444g
445g - 454g
Above 455g
STEP
1. When the ink level becomes low, [NEAR END]
is displayed.
(When ink ends, [INK END] is displayed)
2. Remove the ink cartridge and confirm the
weight of remaining amount of ink.
*Refer to the above table
3. To use the remaining ink, reinsert the ink car-
tridge.
4. Press the[ENTER] key.
If press the [END]key, it cancel the operation and return to
the LOCAL mode.
Ink amount able to add
Do not add
+ 10cc
+ 20cc
+ 30cc
- 5.29 -
• To prevent missing some color or
vertical white line, weigh ink
cartridge correctly.
• This guide table is only a guide.
Be careful not to add too much ink.
< LOCAL >
NEAR END
< LOCAL >
CARTRIDGE
ADD REMAIN ?
- K - - - - - -
ADD REMAIN
Yes : ent
- K - - - - - -
- K - - - - - -
Displayed alternately
No : end