Menu Mode - MIMAKI JV3-75 SP II Operation Manual

MENU mode

There are the following four mode in this device.
Each of the four modes is explained below.
NOT-READY mode
This is the mode before the media detector.
The keys other than the [REMOTE] key are effective.
LOCAL mode
This is the mode after the media detection.
All keys are effective to enable setups.
The device is able to receive data from computer, however, it will not perform plotting.
In this mode, it is possible to perform the following operations.
1. Pressing the appropriate [JOG] keys to detect a media and set up an origin.
2. Pressing the [TEST&CLEANING] key to start test plotting and cleaning the head.
3. Pressing the [DATA CLEAR] key to erase the plotting data the device has received.
4. Pressing the [FUNCTION] key to set plotting conditions. (FUNCTION mode)
5. Pressing the [HEATER] key to set temperature of the heater.
6. Pressing the [ENTER] key to check the remaining amount of ink, the error of cartridges, the
firmware version, and so on.
REMOTE mode
The device plots an image from data it receives.
During the plotting operation, press the [REMOTE] key to interrupt the plotting operation.
FUNCTION mode
This is the mode in which plotting conditions can be set.
While the device is in the LOCAL mode, press the [FUNCTION] key to put the devide into the
FUNCTION mode.
- 1.15 -