Setting The Media On The Device; Setting A Roll Holder - MIMAKI JV3-75 SP II Operation Manual

Setting the media on the device

The media that can be used with the device are roll media and leaf media.
Use the media commended by MIMAKI.
• If a transparent media is set, the following message appears on the LCD
and the media may not be detected.
• If the media is exposed to direct sunshine, the media width may not be
detected correctly.
• Do not use printed media, or ink adheres to a pinch roller and media may
not be detected.
• Strong or internal curled media must be set to be along the platen by rolling
it in the opposite direction.

Setting a roll holder

• Attach the roll holder with two people.
The attachment position (height) of the roll holder can be set in three steps.
Depending on the media, change the attachment position of the roll holder by reducing or increasing
the heater contact time.
To reduce the heater contact time, attach the roll holder at the top position ; to increase the heater
contact time, attach it at the bottom position.
When it is attached to the top or bottom position, it is necessary to use the lock pin to set the media.
page 2.14
1. Remove the four screws, and then remove roll
assembly.
ERROR 50
MEDIA SENSE
- 2.8 -