Interrupting The Printing Operation; After Completing The Printing Operation - MIMAKI Textile Jet Tx3-1600 Operation Manual

Interrupting the printing operation

To interrupt the printing operation that has been started, stop the carriage and erase (the receive data)
from the device.
STEP
1. If data is being transmitted from the computer
to the device, stop the data transmission.
2. Press [REMOTE] key to stop the printing op-
e r a t i o n .
3. Press [CLEAR] key.
The data that has been received is erased.
4. Press [ENTER] key.
The device enters the LOCAL mode.
• When turn the device off still receiving the data or non printing data has
remains, the absorption roller has been risen. Make sure to delete the data
before turning off.

After completing the printing operation

The operation to be performed by the operator at the end of the printing operation (switching off the
power) is explained below.
STEP
1. Put the device back into the LOCAL mode.
2. Turn off the power to the device.
- 2.49 -
<< LOCAL >>
width : 1620mm
DATA CLEAR
< ENT >
<< LOCAL >>
width : 1620mm
<< LOCAL >>
width : 1620mm