The Rear - MIMAKI JV3-75 SP II Operation Manual

The REAR

2
3 *
4 *
11
10
Name
1 Rear exhauster
2 Ink station
3 Ink cartridge
4 Cartridge protection cover *
5 Voltage selector switch
6 IEEE-1394 connector
7 Parallel connector
8 Paper roll setting bar
9 Roll holder
10 AC inlet
11 Main power switch
12 Clamp lever
13 Preheater
13
12
Discharges plotting smell from the media to out of the room.
Set the ink cartridges specified.
Each cartridge contains ink of a specific color.
This cover is protect injuries, etc. due to protrusion of 440cc cartridge.
(In the case of JV3-75SPII, 220cc cartrige is recommended and this
cover sold separetely.)
Switches between 100-120 V and 200-240 V according to the power
voltage used. (JV3-75SPII: 2 switches / JV3-130SPII: 3 switches)
A 400M bps interface connector compatible with IEEE-1394.
Bi-directional parallel interface connector (complies with IEEE1284)
This bar facilitates a paper roll to be set in position.
Roll holder is inserted in the right and left core of roll media to hold the
roll media. The roll holder is applicable to diameter of media cores with
2 and 3 inches. The attachment position (height) of the roll holder can
be set in three steps. To increase the heater contact time, attach it at
the bottom position.
The power cable is connected to the AC inlet.
Turns on/off the main power of the device. Leave the main power turned
on to prevent ink clogging.
Works together with the clamp lever on the font face of the device.
Preheat the media before plotting. ( Attached inside the platen )
- 1.5 -
1 2
* This drawing illustrates 440cc ink cartridges
set to the plotter. JV3-75SPII is supplied with
220cc cartridges as standard equipment.
Function
3 *
4 *
5
6
7
8
9