Paper jamming arises/media is soiled
A jam of the media or a stained media is considered to occur when an unsuitable media is used or
the media is set improperly.
Are you using media specific
to the device?
Are you using media that has
neither curls nor bent ends?
Does the media hang over along
the platen?
The [HEAT] or [CONSTANT] indicator does not go on
Check the basic operation.
Is the power of the device ON?
Is the power of the heater ON?
Is the heater temperature setting
effective?
Yes
Yes
Yes
Yes
No
Use media specific to the device.
Avoid media that has curls or
No
bent ends.
Use a take-up device or re-load
No
the media on the device.
page 2.10, 2.16
No
Turn on the power of the device.
page 2.3
No
Turn on the power of the heater.
Set the temperature of the
No
heater.
- 6.3 -
page 2.18