Table of Contents
Advertisement
3 Printing
STEPS:
1
Check the heater temperatures.
Make sure that the CONSTANT lamps on the heater panel are lit. (See 3-16)
2
Press the [REMOTE] key.
The printer enters REMOTE mode.
The currently selected type (printing conditions) can be confirmed. (Refer to "Registering printing condi-
tions in a lump (type registration) (p.6-2)" )
3
Transmit the data from the computer.
The printing conditions that have been set for the data are displayed.
For the method of data transmission, refer to the instruction manual for the output software.
4
The printer start printing.
During printing, the length of the printed part of the media is displayed.
Interrupting the printing operation
To interrupt the printing operation, stop the carriage by pressing the [REMOTE] key and erase the received
data from the printer.
The next time the printer enters REMOTE mode, it would start printing with the data that was interrupted
if the data has not been erased.
STEPS:
1
Press the [REMOTE] key to stop the printing operation.
The printer returns to LOCAL mode.
If data is being transmitted from the computer to the printer, stop the data transmission.
2
Press the [DATA CLEAR] key.
The data that has been received is erased.
3-34
∗ >
R.
∗ +>
R.
Bd. Vd. x1. 1L :
L. ∗ >
DATA CLEAR
<ENT>
∗∗.∗∗ m
720x1080
.12
∗∗.∗∗ m
width : ∗∗∗∗ mm
∗ ∗ DATA CLEAR ∗ ∗
Advertisement
Table of Contents
