Replace The Cutter Blade - MIMAKI JV3-75 SP II Operation Manual

Replace the cutter blade

Cutter blades are consumables. When the cutter blade has became blunt, replace the cutter blade
with a new one (SPA-0107).
• The blade tip is sharp. Take care to prevent possible personal injury.
• Store the cutter blades in a place that is out of the reach of children.
Be sure to dispose of the worn-out cutter blades according to the relevant
national and local ordinances in which the device is used.
• It is recommended to place a sheet of paper under the cutter blade.
This will help find the cutter blade even if it drops.
STEP
1. Execute [CARRIAGE out].
page 5.4
2. Open the front cover.
3. Replace the cutter unit that is located along-
side the carriage.
1. Loosen the screws that fix the cutter unit.
2. Remove the cutter unit.
3. Put a new cutter unit in place.
4. Tighten the screws to fix the new cutter unit.
4. Close the front cover.
5. Press the [ENTER] key.
The device enters the LOCAL mode.
- 5.25 -
STATION
MENT : CARRIAGE out