Carriage; Heater - MIMAKI JV3-75 SP II Operation Manual

Carriage

The carriage is provided with ink heads for printing, a cutter unit for cutting off media, etc. It is also
provided with a lever for adjusting the head height according to the thickness of the media used.

Heater

The platen has heater built-in for printing and preprinting.
The preheater preheats the media before plotting to prevent rapid temperature change at the printing
section. The print heater improves the plot quality and dries ink after printing.
• While the heater is heating, the platen is very hot. When opening the front
cover or replacing the media, lower the heater temperature and wait until
the platen temperature drops. Doing so while the platen is hot may cause
burn.
• When replacing the media with a thin one, lower the heater temperature and
wait until the platen temperature drops. Doing so while the platen is hot may
cause the media to stick to the platen or cause wrinkles or curls of the
media.
Cutter Unit
- 1.8 -
Adjusting lever