Setup Functions - MIMAKI JV3-75 SP II Operation Manual

Setup functions

The following describes the overview of and settings for each function.
Name
STATION
INT.WIPING
PRINT ADJUST
FILL UP INK
HEAD WASH
Disway WASH
SLEEP clean
CUSTODYwash
LIST
DATA DUMP
WIPE LEVEL
USE 440cc
TIME SET
INFORMATION
Clean the inside of the station and replace the wiper.
(CARRIAGEout, WIPER EXCHANG, NOZZLE WASH)
Wipe off the condensed ink.
Adjust the dot position when changing the media type and/or ink.
Perform this function if nozzle clogging is resolved after head cleaning.
Perform this function if nozzle clogging is resolved after head cleaning.
Wash the ink discharge way (from the ink cap to the waste ink tank).
Perform head cleaning and flushing operation to prevent from nozzle-out phenomenon.
When not in use the plotter over a week, perform the function to wash the head
nozzle and ink discharge way.
Plotting the set condition of the device.
Plotting data commands received from the computer, in HEX code.
Makes setting to move up the wiper replacement warning depending on the operating
environment.
Enabling the use of 440cc cartridge with JV3-75SPII.
Sets the date and time of the built-in calender of the device.
Displays the firmware version, serial number, and dealer number of the device.
Function
- 5.3 -
page 5.4
through 5.6
page 5.7
page 5.9
page 5.11
page 5.11
page 5.13
page 5.15
page 5.16
page 5.18
page 5.19
page 5.20
page 5.21
page 5.21
page 5.22