Chapter 2 Operation - MIMAKI JV3-75 SP II Operation Manual

This chapter describes a series of operations and settings, ranging from power-on to
end of plotting.
Operation ....................................................................................................... 2.2
Switching on the power supply ...................................................................... 2.3
Turning the power on ...................................................................................... 2.3
Front cover /Maintenance cover .................................................................... 2.4
Opening/closing the front cover and maintenance cover ................................ 2.4
Cautions during operation ............................................................................... 2.4
Relationships between ink station and head row .......................................... 2.5
Adjusting the head height .............................................................................. 2.6
Setting the media on the device .................................................................... 2.8
Setting a roll holder .......................................................................................... 2.8
Setting roll media on the device .................................................................... 2.10
Operating the lock pin ................................................................................... 2.14
Switching the direction of winding of the media ............................................ 2.15
Setting the torque limiter ............................................................................... 2.15
Setting cut sheet media on the device .......................................................... 2.16
Changing the drier fan angle ..........................................................................2.18
Heater-Temperature control ........................................................................ 2.19
In case of faultiness with Heater ................................................................... 2.20
Checking and solving nozzle clogging (TEST plotting) ............................... 2.21
Correcting the media feed rate [MEDIA COMP.] ......................................... 2.23
Correcting the media feed rate during operation ......................................... 2.25
Plotting an Image from source data ............................................................ 2.26
Starting the plotting operation ........................................................................2.26
Interrupting the plotting operation ...................................................................2.27
Cut off the media by hand ............................................................................. 2.27
When [NEAR END] or [INK END] appears .................................................. 2.28
Ink cartridge trouble..................................................................................... 2.29
Turning the power off ................................................................................... 2.30
Table of contents
- 2.1 -
CHAPTER 2
Operation