Setting The Heater Voltage - MIMAKI JV3-75 SP II Operation Manual

Setting the heater voltage

Set the heater voltage according to the supply voltage to the plotter.
For the voltage setting, use the voltage selectors under the left back of the cover.
At shipping from the factory, the voltage is set to 220 V for safety.
• The plotter may be damaged if it is plugged to a 200-240V source while the
voltage selector is set to 110V.
• The heater temperature will not rise to the set temperature if it is plugged to
a 100-120V source while the voltage selector is set to 220V.
Connecting to a 100-120V source
(As for JV3-75SPII, set the two voltage selectors.)
Connecting to a 200-240V source
(As for JV3-75SPII, set the two voltage selectors.)
- 1.14 -