Interrupting The Printing Operation - MIMAKI GP-1810 Operation Manual

4. During the printing.
5. After the printing operation is completed, put
the machine back into the LOCAL mode.
The table will move toward you when printing in the Cycle
Start mode.
• The origin and the print area remain un-
changed after printing. You must reset them
if they need to be changed. (

Interrupting the printing operation

To interrupt the printing operation, stop the carriage and erase (the receive data) from the machine.
STEPS:
1. Press the [REMOTE] key to stop the printing
operation.
2. If data is being transmitted from the computer
to the machine, stop the data transmission.
3. Press the [DATA CLEAR] key.
The data that has been received is erased.
4. Press the [DATA CLEAR] key or [ENTER] key.
The machine enters the LOCAL mode.
• The green pilot lamp indicates that there is no data in the machine.
Printing an image from source data
page 2.9)
- 2.17 -
<< LOCAL >>
X =1010 Y = 1860
<< LOCAL >>
X =1010 Y = 1860
DATA CLEAR
< ENT >
<< LOCAL >>
X =1010 Y = 1860