Error Messages - MIMAKI JV3-75 SP II Operation Manual

Error messages

Error messages indicates error numbers.
If any error message is given on the LCD, turn off the power to the device and turn it on after a
while.
If the same error message appears again on the LCD, contact your local MIMAKI distributor or
MIMAKI office to call for service.
Error message
ERROR 01
MAIN ROM
ERROR 02
MAIN RAM
ERROR 03
POWER +5V
ERROR 04
FRASH ROM
ERROR 06
D-RAM
ERROR 07
HEAD − − ∗ − − −
ERROR 08
ENCODER n
ERROR 09
HDC
ERROR 10
COMMAND
ERROR 11
PARAMETER
ERROR 20
I / F BOARD
ERROR 21
I / F NONE
Cause
Control circuit board is defective.
Control circuit board is defective.
POWER+5V
POWER+35V
Control circuit board is defective.
Head connection failure is
detected.
Trouble with detection of linear
encoder.
Control circuit board is defective.
FPGA Error
HDC Error
The device has received data
other than command data.
The interface cable used is not in
conformance with this plotter.
A parameter outside the range of
acceptable numeric values is
received.
Improper operation has been
conducted on the operation panel.
No I/F board is attached to the
control board.
- 6.8 -
Corrective measure
Turn off the power to the device
an turn it on after a while. If the
same error message appears again
on the LCD, contact your local
distributor to call for service.
Securely connect the interface
cable in position. Use an interface
cable in conformance with the
standard.
Turn off the power to the device
and turn it on after a while. If the
same error message appears again
on the LCD, contact your local
distributor to call for service.