Interrupting the plotting operation
To interrupt the plotting operation, stop the carriage and erase (the receive data) from the device.
STEP
1. Push the [REMOTE] key to stop the plotting
operation.
2. If data is being transmitted from the computer
to the device, stop the data transmission.
3. Push the [DATA CLEAR] key.
The data that has been received is erased.
4. Push the [ENTER] key.
The device enters the LOCAL mode.
After completing the plotting operation
Cutting off the medium at the end of the plotting operation is explained below.
• When Auto Cut has not been specified (
using the following procedure.
STEP
1. Put the device back into the LOCAL mode.
Push the [REMOTE] key and put the device back into the
LOCAL mode.
2. Push the [JOG] key until the LCD gives the
indication [ORIGIN SET UP].
Any of the JOG keys can be used.
3. Push the [FUNCTION] key.
4. Push the [ENTER] key.
Cut off the medium that has been plotted on.
5. The device enters the LOCAL mode.
The device returns to its initial condition.
page 4.7), cut off the medium
- 2.22 -
< LOCAL >
width : 1272 mm
DATA CLEAR
< ENT >
< LOCAL >
width : 1272 mm
< LOCAL >
width: 1272 mm
ORIGIN SET UP
0. 0
- - - - - -
MEDIA CUT
< ENT >
MEDIA CUTTING
PLEASE WAIT
< LOCAL >
width : 1272 mm