Interrupting the plotting operation
To interrupt the plotting operation, stop the carriage and erase (the receive data) from the device.
STEP
1. Push the [REMOTE] key to stop the plotting
operation.
2. If data is being transmitted from the computer
to the device, stop the data transmission.
3. Push the [DATA CLEAR] key.
The data that has been received is erased.
4. Push the [ENTER] key.
The device enters the LOCAL mode.
After completing the plotting operation
Cutting off the media at the end of the plotting operation is explained below.
STEP
1. Put the device back into the LOCAL mode.
Push the [REMOTE] key and put the device back into the
LOCAL mode.
2. Push the [JOG] key until the LCD gives the
indication [ORIGIN SET UP].
Any of the JOG keys can be used.
3. Push the [FUNCTION] key.
4. Push the [ENTER] key.
Cut off the media that has been plotted on.
5. The device enters the LOCAL mode.
The device returns to its initial condition.
Downloaded From ManualsPrinter.com Manuals
• Do not turn off the main power switch on the rear face. If the main power
switch is turned off, the nozzle will be clogged.
• When Auto Cut has not been specified (
using the following procedure.
< LOCAL >
DATA CLEAR
< LOCAL >
page 4.7), cut off the media
- 2.37 -
width : 2475 mm
< ENT >
width : 2475 mm
< LOCAL >
width: 2475 mm
ORIGIN SET UP
0. 0
- - - - - -
MEDIA CUT
< ENT >
MEDIA CUTTING
PLEASE WAIT
< LOCAL >
width : 2475 mm