Nozzle Check - Oce CS9360 User Manual

Step 7: Press [Cancel] to exit from test print.
The operation panel returns to Normal.

3.3.1

Nozzle check

It is used to check whether there are any clogged heads, or missing or blurred prints.
NOTE
If the nozzle check result indicates that the checked points are blurred or missing, clean

the head. 6.2.3 Head cleaning
Perform the nozzle check once again at the end of the work.
TIP
Refer to the following for printing procedure.

3.5 Test print
3-40
CS9360 User's Guide