Registration Mark Offset Range; Contour Cutting - MUTOH VC-600 User Manual

Automatic Aligning System
Note:

Before adjusting the AAS II settings, please proceed scaling for width and length.

The blade offset value isn't set for this test graphic, please set it according to the blade you
use.

If you have any question, please contact us or your local distributor for assistance.

5.4 Registration Mark Offset Range

Please correctly load your media (refer to the alignment ruler on the platen) to make sure the registration
marks are successfully detected. Deviation exceeds the range below will lead to detection failure.

5.5 Contour Cutting

For accurate contour cutting with AAS function, please proceed the following steps:
Step 1
Creating Graphics

Create the graphic that you want to print and cut in your software.

Create a contour for cutting around the graphic.
58
ValueCut USER MANUAL
V5a 2015 Jan