Aas Offset Test - MUTOH ValueCut II VC2-600 User Manual

ValueCut USER MANUAL

5.3 AAS Offset Test

Before performing AAS contour cutting, it's recommended to print out a test file that you can find in the
enclosed Installation CD to make sure the AAS II cutting accuracy of ValueCut.
There are two testing files for AASII:
AAS offset Calibration.pdf (Print data)
AAS offset Calibration.plt (Cutting data)
1. Print out the testing graphic. (Please use high precision printer)
2. Load the graphic to ValueCut and sent the Cutting data to test the cutting job.
You can output the cutting data from Production Manager of FlexiSTARTER.
3. If there are any adjustments to be made, you can change the offset value by following the steps:

Measure the offset values from the printed line and the actual cutting line.

Enter the AAS Offset under MISC function for the values you just measured, then
press Enter.

Test the cutting again.

AAS II offset X and Y value is defined as following:
Horizontal line is defined as X and vertical is defined as Y. (when facing the cutting
plotter)
When the actual cutting line and the printed line need to be changed towards the
direction of origin mark, then simply add the negative value of the offset. If the
direction is from the opposite of the origin mark, then enter positive values for the
offset (see the following figures). This method applies to both X and Y axes.
VC2E-A-00
Cutting line
Printing line
X : - Value
Y : - Value
Origin
61
Automatic Aligning System
X : +Value
Y : - Value