User's Guide Kona cutting plotter
Basics
3.3.3
Replace sheet-off blade
Caution
Be careful not to cut your fingers when replacing the sheet-off blade!
Please follow the procedure below to replace the sheet-off blade:
Step 1:
Step 2:
Note
Be aware that the knife is held in its position with a magnet.
Step 3:
Step 4:
40
Loosen the screw fixing the sheet-off blade and protection plate with a hexagon key
of 2,5 mm.
Remove the protection plate and sheet-off blade.
Replace the sheet-off blade or rotate it (4 cutting sides) and reinstall all the parts.
Tighten the screw firmly and verify that the assembly has been reinstalled correctly
by performing an automatic or manual sheet-off.
Refer to
Sheet off on page 89
Refer to
Sheet off on page 121
AP-75380 - Revision 1.2