Removing A Diskette Drive From The Converted Hard Drive Bay - Gateway 9515 User Manual

Removing a diskette drive from the converted hard
drive bay
To remove a diskette drive from the converted drive bay:
1
Follow the instructions in
sure you turn off the server, then unplug the power cord and all other cables connected
to the server.
Caution
2
Follow the instructions in
3
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
4
Pull up on the top of the connector on the backplane marked "Floppy Con" to release
the flat flex cable. See
connector.
5
Push in on the lever at the back of the drive carrier to release the drive carrier from
the drive bay, then slide the diskette drive carrier out through the front of the server.
6
Pull up on the top of the connector on the back of the diskette drive and remove the
flat flex cable.
7
Remove the four screws securing the rails to the carrier, then remove the rails.
8
Remove the two screws securing the diskette drive in the carrier, then slide the drive
out of the carrier.
9
If you are replacing the drive, follow the instructions in
converted hard drive bay" on page
- OR -
Install an empty hard drive carrier into the empty hard drive bay.
10
Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
11
Follow the instructions in
12
Reconnect all power cords and peripheral device cables, then turn on the server.
60
"Preventing static electricity discharge" on page
The diskette drive is not hot-swappable. Before installing or removing
the drive, make sure that power is turned off.
"Opening the server case" on page
"Hot-swap backplane" on page 8
56.
"Closing the server case" on page
www.gateway.com
43. Make
44.
for the location of the
"Installing a diskette in a
46.