Installing Or Replacing A Hard Drive - Gateway E-9220T User Manual

Installing or replacing a hard drive

Use these instructions to install or replace a hard drive.
Important
To install a hard drive in an internal drive bay:
1
Follow the instructions in
2
Follow the instructions in
3
If you are replacing a drive, go to
- OR -
If you are adding a new drive to an available drive bay, slide the green drive retainer
lever toward the front of the drive bay, then go to
4
Disconnect the old drive's cables from the front of the drive.
5
Slide the green drive retainer lever toward the front of the drive bay, then pull the
drive out of the bay.
6
Set any jumpers on the new drive. See the drive's documentation for further
instructions.
To install a hard drive in the bottom external 3.5-inch drive bay, follow
the instructions in "To install a drive in an external drive bay:" on
page 39.
"Preventing static electricity discharge" on page
"Opening the server case" on page
Step
www.gateway.com
4.
Step 7.
Installing drives
29.
30.
Drive retainer
lever
41