Basic Operation; Power-Up Procedure - Christie CP2000 Setup Manual

3 Basic Operation

This section describes how to use controls and switches for basic operation of the projector once it is
properly installed, aligned and configured by a qualified service technician.
3.1

POWER-UP PROCEDURE

Do not attempt operation if the AC supply and pedestal are not within the specified
voltage range.
NOTE: This is a manual power-up procedure. Some cinema installations may include an automation
system that controls lamp ignition in conjunction with other theatre variables, such as house lights,
audio and the start of the feature from a digital media storage device/server.
1. Ensure the breakers at the main wall panel for the CP are switched ON.
2. At the operator's side of the pedestal, set all CP2000 circuit breakers to ON. This includes the AC
(3-phase), the projection head (2-phase) and internal outlets (single-phase). The MAIN AC light
turns green if AC is present, components such as fans and power supplies start up and the TPC
begins initializing (Figure 3-1 Power-up Procedure).
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)
WARNING
F 3-1 P - P
IGURE OWER UP ROCEDURE
3-1