Tpc Power-Up Defaults; Failed Tpc Connection - Christie CP2000 Setup Manual

Section 3: Basic Operation
incoming resolution, offset (rare) and desired final aspect ratio. Screen files determine image crop-
ping (masking), size of display area, lens type and color gamut information ensures color display
standards are properly met in the current environment. In the IP Config menu, the administrator can
define new Ethernet settings (IP network addresses) for the projection head and TPC.
• Installers and other Service personnel can access two additional configuration menus (General,
Lamp), as well as three more Status submenus (Server, Diag and Interrogator). The installer can
define system operating parameters such as which projector is controlled by the TPC and critical
lamp parameters, such as installed lamp type, fan speed and light level at the screen. Installers can
also establish temperature scale preference, remote access rights, test pattern access rights, extent of
data logging. An installer can see ID and error information for servers, as well as a detailed diagnos-
tics log for in-depth troubleshooting.

3.3.2 TPC POWER-UP DEFAULTS

When the CP2000 powers up the TPC begins initializing, attempts to log on and updates status,
displaying its progress on the TPC status bar at the bottom of the screen. When initializing is complete,
all files are refreshed on the TPC and the system is in a ready-to-use default operating mode:
• The Main menu appears on the TPC where you can press the Lamp button to turn on the lamp.
• The most recently used display button is depressed (darkened). Upon turning on the lamp, the image
will appear.

3.3.3 FAILED TPC CONNECTION

If the TPC fails to initialize and instead displays a communication error such as No connection or
Cannot Locate Ethernet Port or Waiting to Connect, there is likely a bad connection
or address between the TPC and the rest of the projector. Check that TPC cabling is intact and try
again. Refer to
Section 5
tor.
3-4
Troubleshooting. If the problem persists, contact your network administra-
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)