Upper Portion Of Display Waving, Tearing Or Jittering; Portions Of Display Cut-Off Or Warp To The Opposite Edge; Display Appears Compressed (Vertically) - Christie CP2000 Setup Manual

5.6.4 UPPER PORTION OF DISPLAY WAVING, TEARING OR JITTERING

This can sometimes occur with video or VCR sources. Check your source.

5.6.5 PORTIONS OF DISPLAY CUT-OFF OR WARP TO THE OPPOSITE EDGE

Resizing may need adjustment. Adjust until entire image is visible and centered.

5.6.6 DISPLAY APPEARS COMPRESSED (VERTICALLY)

1. The frequency of the pixel sampling clock is incorrect for the current source.
2. Sizing and positioning options may be adjusted poorly for the incoming source signal.
3. Use an anamorphic lens for typical HDTV and anamorphic DVD sources that have been re-sized
and vertically stretched via 3rd-party software.
5.6.7 DATA IS CROPPED FROM EDGES
To display the missing material, reduce image size to fill the display area available in the projector,
then stretch vertically to fill the screen from top to bottom. Add the anamorphic lens to regain image
width.
5.6.8 DISPLAY QUALITY APPEARS TO DRIFT FROM GOOD TO BAD AND VICE
VERSA
1. The source input signal may be of low quality.
2. The H or V frequency of the input may have changed at the source end.
5.6.9 DISPLAY SUDDENLY FREEZES
If the screen blacks out inexplicably, it is possible that excessive voltage noise on the AC or ground
input has interrupted the projector's ability to lock on to a signal. Power down the projector
Procedure) and unplug. Then plug in again and power up as usual
Power Down
Procedure).
5.6.10DISPLAY COLORS NOT ACCURATE
1. The color, tint, color space and/or color temperature settings may require adjustment at your input
source.
2. Make sure you are using the proper PCF, TCGD and/or CSC file for this source.
5.6.11DISPLAY NOT RECTANGULAR
1. Check leveling of the projector. Ensure the lens surface and screen are parallel to one another.
2. If necessary, correct the vertical offset using the vertical offset knob.
3. Ensure the anamorphic lens is straight. If necessary, rotate the lens to orient the aperture correctly.
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)
Section 5: Troubleshooting
(3.2
(3.1 Power-Up
5-5