Ac/Power Precautions; Lamp Precautions; Wear Protective Clothing - Christie CP2000 Setup Manual

Section 4: Maintenance
exposed to cumulative radiation levels exceeding the government guidelines for your area. 2) Be
aware that some medications are known to increase sensitivity to UV radiation.
Fire Hazard. Keep hand, clothes and all combustible material away from the
concentrated light beam of the lamp.
This projector must be installed on the floor only and operated in an environment with the correct
operating range specifications. For more information, refer to Section 8: Specifications, outlined in
the CP2000 User's Manual.

4.1.3 AC/POWER PRECAUTIONS

Do not attempt operation if the AC supply and pedestal are not within the specified
voltage range.
Shock Hazard. Disconnect from AC before opening any enclosure. Disconnect at both
wall breakers.
Projector installation requires that an electrician hard-wires a 3-phase (Y) feed and a separate 15A
single-phase feed from the pedestal toe to the AC supply in your building. Use only the correct
pedestal for your geographic area. Operate the projector at the specified voltage.
Do not allow anything to rest on the power cord. Locate the projector where the cord cannot be walked
on or rolled over. Never operate the projector if the power cable appears damaged in any way.
Do not overload power outlets and extension cords to avoid fire or shock hazards.
Only qualified service technicians are permitted to open any enclosure and only if AC has been fully
disconnected at both wall breakers.

4.1.4 LAMP PRECAUTIONS

WEAR PROTECTIVE CLOTHING

Never attempt to remove the lamp directly after use. The lamp is under increased
pressure when hot and may explode, causing personal injury and/or property damage.
Allow to cool completely.
Never open the lamp door unless you are wearing authorized protective clothing, which is included in
the Christie Protective Clothing Safety Kit (#598900-095). Recommended protective clothing includes
- but may not be limited to - protective gloves, latex lab gloves, double-layer 0.040" acetate face
shield, and a quilted ballistic nylon jacket or welder's jacket.
NOTES: 1) Christie's protective clothing recommendations are subject to change. 2) Any local or
federal specifications take precedence over Christie recommendations.
4-2
WARNING
WARNING
WARNING
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)