Table of Contents
Advertisement
8. Connect lamp leads (Figure 2-9 Route Lamp Leads Up and Connect Positive (+) White).
At the igniter:
Make sure the PCB directs to the back and remains at least 3/4" from the high-voltage
terminal (with braid connection).
Route all igniter wires AWAY from 9-pin and 15-pin connectors.
Twist both ballast cables twice-per-foot.
• Ensure igniter door is open. From the ballast in the pedestal, route the main black and white lamp
leads through the nearby hole in the underside of the projection head (Figure 2-9 Route Lamp Leads
Up and Connect Positive (+) White).
• Route the NEGATIVE (-) BLACK lamp lead through the hole in the lamp cooling compartment wall
(Figure 2-9 Route Lamp Leads Up and Connect Positive (+) White).
• Connect the POSITIVE (+) WHITE lamp lead to the POSITIVE (+) igniter terminal. This terminal
also has a small PCB attached-stack this on top of the lamp lead (Figure 2-9 Route Lamp Leads Up
and Connect Positive (+) White).
• Close and lock the igniter door.
F
IGURE
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)
WARNING
2-9 R
L
L
OUTE
AMP
EADS
Section 2: Installation and Setup
U
C
P
P AND
ONNECT
OSITIVE
(+) W
HITE
2-7
Hide quick links:
Advertisement
Table of Contents
