Offset And Boresight Alignment; Adjust Offset - Christie CP2000 Setup Manual

2.8

OFFSET AND BORESIGHT ALIGNMENT

NOTES: 1) Projector must be fully assembled and powered up in its final location. Install the
anamorphic lens, if it will be used at the site. 2) You will need a 3/16" Allen wrench.
To ensure proper offset for your site and consistently good focus in all areas of the screen, a primary
lens must be installed and its lens mount precisely adjusted in relation to internal optics. If desired, an
anamorphic lens can then be added to widen images for "scope" cinema displays.
Refer to lens mount components, illustrated in Figure 2-35 for these adjustments.

2.8.1 ADJUST OFFSET

Project an image with the primary lens only. The
optional lens, if present, can be mounted but swung
aside.
Adjust horizontal and vertical offsets as necessary
(Figure 2-36 Offsets) so that the image is square on-
screen, but offset is minimal. Always adjust offset
before boresight.
NOTE: For best optical performance, make sure to
minimize offsets by "aiming" the projector lens at the
center of the image.
The maximum vertical offset is shown in Figure 2-37/
bottom.
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)
F 2-35 L M
IGURE ENS OUNT
Section 2: Installation and Setup
A
NATOMY
F 2-36 O
IGURE FFSETS
2-25