Projector Head And Pedestal; Secure Projector Head To Pedestal - Christie CP2000 Setup Manual

Section 2: Installation and Setup
•
For CP2000-S Models

2.1.2 PROJECTOR HEAD AND PEDESTAL

SECURE PROJECTOR HEAD TO PEDESTAL

It is recommended that two people perform the following procedure.
For cable connections, maintain cable ties that have been trimmed and remove those
that are not.
1. Roll the pedestal as close as possible to its permanent location, with its front toe facing the port
window wall.
2. Inside the pedestal, at the rear of the top frame, turn the knob to extend the safety prop above the
pedestal frame. This "stop" elevates the rear of the projection head until fingers are safely out of
the way (Figure 2-1/Step 1).
3. Lift the projection head onto the pedestal, aligning the four threaded rods with the four holes in the
pedestal frame. The front of the head sits on the front of the pedestal frame and the rear is elevated
by the safety prop.
4. Retract the safety prop until the rear of the projection head sits on the rear of the pedestal frame.
All four threaded rods will be fully inserted through the holes in the top of the pedestal. Secure
prop (do not leave loose).
5. Secure head-pedestal assembly with four washers/nuts tightened snugly onto the four threaded
rods.
2-2
- Refer to the
Addendum for Installation and Use
WARNING
F 2-1 A P
IGURE SSEMBLE
H P
ROJECTION EAD WITH
provided.
EDESTAL
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)